模板
教程
环境
性能
功能
管理
Stop-A on Serial Console?
发表于：2007-06-09来源：作者：点击数：
标签：
使用Sun的机器,由于没有显卡,只能使用串口了 由于找不到Stop键,没有办法使用Stop-A的操作 如下是精华,呵呵: See if the online docs reference a BREAK signal. 正解 Subject: Stop-A on Serial Console? Original Message Name: Greg (by inittab) Date: Jul
使用Sun的机器,由于没有显卡,只能使用串口了由于找不到Stop键,没有办法使用Stop-A的操作
如下是精华,呵呵:
See if the online docs reference a "BREAK" signal.
正解
Subject: Stop-A on Serial Console?
|
|
|
Name: Greg (by inittab) Date: July 29, 2004 at 12:18:19 Pacific Subject: Stop-A on Serial Console? OS: N/A CPU/Ram: 300MHz, 256mb |
clearcase/" target="_blank" >cc">
Comment: Is it possible to send Stop-A to a Sun Ultra 30 over a serial console? Unfortunately, the system that I'm connecting from runs Linux and therefor does not support `tip`. Hence, I am using Columbia's Kermit (`kermit`) to establish the connection. Everything works as expected from the boot banner to the console login, but I would like to be able to halt the system without booting the operating system first, so I need to figure out how to send such a command (Stop/L1-A). Thank you. Report Offensive Message For Removal |
|
|
|
Name: David Perry Date: August 02, 2004 at 09:23:48 Pacific Subject: Stop-A on Serial Console? |
Reply: It depends a lot on your terminal package. Some key sequences to try Report Offensive Follow Up For Removal |
|
|
|
Name: nrc Date: August 04, 2004 at 18:59:57 Pacific Subject: Stop-A on Serial Console? |
Reply: could also use alt-b, if using teraterm Report Offensive Follow Up For Removal |
