• 软件测试技术
  • 软件测试博客
  • 软件测试视频
  • 开源软件测试技术
  • 软件测试论坛
  • 软件测试沙龙
  • 软件测试资料下载
  • 软件测试杂志
  • 软件测试人才招聘
    暂时没有公告

字号: | 推荐给好友 上一篇 | 下一篇

RFC692 - Comments on IMP/Host Protocol changes (RFCs 687 and 690)

发布: 2007-6-23 14:09 | 作者:   | 来源:   | 查看: 12次 | 进入软件测试论坛讨论

领测软件测试网

   
  Network Working Group Stephen Wolfe
RFC# 692 UCLA CCN
NIC # 32734 June 20, 1975

COMMENTS ON IMP/HOST PROTOCOL CHANGES, (RFCS 687 AND 690)

Basically, the proposed set of changes in RFC687 seems reasonable, as

are the comments in RFC690.

The major problem, as pointed out by Postel, is the change in the
combined length of the IMP and Host leaders to a total of 120 bits,
which is not a multiple of both 8 and 36 bits.

The suggested solution is to increase the length of the host to host
protocol leader by 24 bits, creating a total length of 144 bits. The
problem, however, is that the only way of compatibly changing this
length would be to have the IMP either insert or delete the extra 24
bits when converting to/from the old format leader. The problems with
this solution are obvious.

The better solution is to change the length of the new proposed IMP
leader. I suggest 104 bits instead of 80 bits. The complaint that 104
is not a multiple of an IMP word is valid, but it should not be that
difficult if the following rules are observed.

1. The last 8 bits are never used to convey information.

2. The network is not required to pass them from source to
destination, or to return them to the source.

3. When sending messages of types other than zero, (irregular
messages), the IMP is allowed to send either 96, 104 or 112 bits
of data, the choice being at the IMP's convenience.

4. Also, if desired, either 96 or 112 could be used as the new
leader length for irregular messages.

It must be faster (and cheaper) to just change the IMP program to handle
a 104 bit leader, than to force additional changes in all hosts using
the standard protocol.

Another suggested extension to the protocol would add a new type of IMP
to Host message. This message has a table of Host names (people type
character strings) and Host network addresses. Send this message(s) to
the Host after each interface reset, or alternatively, it could be a
response to a new Host to IMP request for this information.

[ This RFCwas put into machine readable form for entry ]
[ into the online RFCarchives by Alex McKenzie with ]
[ support from GTE, formerly BBN Corp. 10/99 ]

文章来源于领测软件测试网 https://www.ltesting.net/


关于领测软件测试网 | 领测软件测试网合作伙伴 | 广告服务 | 投稿指南 | 联系我们 | 网站地图 | 友情链接
版权所有(C) 2003-2010 TestAge(领测软件测试网)|领测国际科技(北京)有限公司|软件测试工程师培训网 All Rights Reserved
北京市海淀区中关村南大街9号北京理工科技大厦1402室 京ICP备10010545号-5
技术支持和业务联系:info@testage.com.cn 电话:010-51297073

软件测试 | 领测国际ISTQBISTQB官网TMMiTMMi认证国际软件测试工程师认证领测软件测试网