• 软件测试技术
  • 软件测试博客
  • 软件测试视频
  • 开源软件测试技术
  • 软件测试论坛
  • 软件测试沙龙
  • 软件测试资料下载
  • 软件测试杂志
  • 软件测试人才招聘
    暂时没有公告

字号: | 推荐给好友 上一篇 | 下一篇

SM240第四章读书笔记

发布: 2007-6-08 22:43 | 作者: seanhe | 来源: | 查看: 19次 | 进入软件测试论坛讨论

领测软件测试网 System boards

main contents:
identify the diffenent system and CPU boards used in Sun Enterprise servers
identify each I/O board type and the peripheral devices they support
describe the function of the Clock+ board
remove and replace a CPU module

The system's main logic board provides sixteen slots for high-capacity dual in line memory modules(DIMMs). the system supports sun standard 200-pin ,5-volt, 60-nanosecond memory modules. modules of 32- 64- and 128-Mbyte capacities can be installed in the system

The following rules apply to configuring the systems memory:
memory DIMMs must be added four at a time within the same bank
each bank used must have four identical capacity DIMMs installed
memory bank A must always be filled
DIMM capacities can differ from one bank to the next

The enterprise systems support the five types of I/O boards identified as follows:
type1-SBus I/O board with FC-OM fibre Channel
type4-SBus+I/O board with FC-AL fibre Channel
type2-Graphics I/O board with FC-OM fibre Channel
type5-Graphics+I/O board with FC-AL fibre Channel
type3-PCI+ I/O board

The clock+ board provides:
programmable system and processor clock
serial,keyboard,and mouse ports for the console
centralized time-of-day(TOD) chip that includes NVRAM
centralized reset logic
status and control of power supplies

The clock+ board allows you to connect an ASCII terminal to the serial port and a Sun keyboard and mouse to the keyboard port. This allows you to interface to the local system console. The serial port allows POST messages to be displayed to a local ASCII terminal

The following lists the general LED condition rules for the CPU/Memory+ and I/O+ boards:
if no LEDs are lit, there is no electrical power to the board
if the green power and running LEDs are not lit, the board is ready for removal
if no LEDs are flashing, the system is hung or in the process of booting up
the board requires service if the yellow service LED is lit continuously. it is a normal condition for the service LED to flash during POST testing

延伸阅读

文章来源于领测软件测试网 https://www.ltesting.net/


关于领测软件测试网 | 领测软件测试网合作伙伴 | 广告服务 | 投稿指南 | 联系我们 | 网站地图 | 友情链接
版权所有(C) 2003-2010 TestAge(领测软件测试网)|领测国际科技(北京)有限公司|软件测试工程师培训网 All Rights Reserved
北京市海淀区中关村南大街9号北京理工科技大厦1402室 京ICP备10010545号-5
技术支持和业务联系:info@testage.com.cn 电话:010-51297073

软件测试 | 领测国际ISTQBISTQB官网TMMiTMMi认证国际软件测试工程师认证领测软件测试网