RFC1879 - Class A Subnet Experiment Results and Recommendations

领测软件测试网

　　 
　　Network Working Group B. Manning, Editor
Request for Comments: 1879 ISI
Category: Informational January 1996

Class A Subnet Experiment
Results and Recommendations

Status of this Memo

This memo provides information for the Internet community. This memo
does not specify an Internet standard of any kind. Distribution of
this memo is unlimited.

Discussion/Purpose

This memo documents some experiences with the RFC1797 [1] subnet A
experiment (performed by the Net39 Test Group (see credits)) and
provides a number of recommendations on future direction for both the
Internet Registries and the Operations community.

Not all proposed experiments in RFC1797 were done. Only the "case
one" type delegations were made. Additional experimentation was done
within the DNS service, by supporting a root nameserver and the
primary for the domain from within the subnetted address space. In
addition, testing was done on classless delegation [2].

Internet Services offered over the RFC1797 experiment were:

Finger
HTTP
Telnet
FTP server/client
Gopher
kerberos
lpr (and its ilk)
X
DNS

F.Root-Servers.Net, a root name server had an interface defined as
part of the RFC1797 experiment. Attached is a report fragment on
it's performance: "My root server has processed 400,000,000 queries
in the last 38 days, and well over half of them were to the temporary
39.13.229.241 address (note that I retained the old 192.5.5.241
address since I knew a lot of folks would not update their root.cache
files and I didn't want to create a black hole.)" - Paul Vixie

Initial predictions [3] seemed to indicate that the safest path for
an ISP that participates in such a routing system is to have -all- of
the ISP clients be either:

a) singly connected to one upstream ISP
OR
b) running a classless interior routing protocol

It is also noted that a network with default route may not notice it
has potential routing problems until it starts using subnets of
traditional A's internally.

Problems & Solutions

Operations

There were initial problems in at least one RIPE181 [4]
implementation. It is clear that operators need to register in the
Internet Routing Registry (IRR) all active aggregates and delegations
for any given prefix. Additionally, there need to be methods for
determining who is authoritative for announcing any given prefix.

It is expected that problems identified within the confines of this
experiment are applicable to some RFC1597 prefixes or any "natural"
class "A" space.

Use of traceroute (LSRR) was critical for network troubleshooting
during this experiment. In current cisco IOS, coding the following
statement will disable LSRR and therefore inhibit cross-provider
troubleshooting:

no ip source-route

We recommend that this statement -NOT- be placed in active ISP cisco
configurations.

In general, there are serious weaknesses in the Inter-Provider
cooperation model and resolution of these problems is outside the
scope of this document. Perhaps the IEPG or any/all of the national
or continental operations bodies [5] will take this as an action item
for the continued health and viability of the Internet.

Routing

A classic cisco configuration that has the following statements

ip route 39.1.28.0 255.255.255.0
router bgp 64000
redistribute static

will, by default, promote any classful subnet route to a full
classful route (supernet routes will be left alone). This behaviour
can be changed in at least the following two ways:

1:
ip route 39.1.28.0 255.255.255.0
router bgp 64000
no auto-summary
redistribute static

2:
ip route 39.1.28.0 255.255.255.0
router bgp 64000
network 39.1.28.0 mask 255.255.255.0
redistribute static route-map static-bgp
....
access-list 98 deny 39.1.28.0 0.255.255.255
access-list 98 permit any
....
route-map static-bgp
match ip address 98

Users of cisco gear currently need to code the following two
statements:

ip classless
ip subnet-zero

The implication of the first directive is that it eliminates the idea
that if you know how to talk to a subnet of a network, you know how
to talk to ALL of the network.

The second is needed since it is no longer clear where the all-ones
or all-zeros networks are [6].

Other infrastructure gear exhibited similar or worse behaviour.
Equipment that depends on use of a classful routing protocol, such a
RIPv1 are prone to misconfiguration. Tested examples are current
Ascend and Livingston gear, which continue to use RIPv1 as the
default/only routing protocol. RIPv1 use will create an aggregate

announcement.

This pernicious use of this classful IGP was shown to impact
otherwise capable systems. When attempting to communicate between an
Ascend and a cisco the promotion problem identified above, was
manifest. The problem turned out to be that a classful IGP (RIPv1)
was being used between the Ascends and ciscos. The Ascend was told to
announce 39.1.28/24, but since RIPv1 can't do this, the Ascend
instead sent 39/8. We note that RIPv1, as with all classful IGPs
should be considered historic.

This validates the predictions discussed in [3].

Cisco Specific Examples

There are actually three ways to solve the unintended aggregation
problem, as described with current cisco IOS. Which of them applies
will depend on what software version is in the router. Workarounds
can be implemented for ancient (e.g., 8.X) version software.

o Preferred solution: turn on "ip classless" in the
routers and use a default route inside the AS.
The "ip classless" command prevents the existence of
a single "subnet" route from blocking access via the
default route to other subnets of the same old-style network.
Default only works with single-homed ISPs.

o Workaround for 9.1 or later software where the
"ip classless" command is not available: install a
"default network route" like this:
"ip route 39.0.0.0 255.0.0.0 <next-hop>" along the axis
the default route would normally take. It appears
an ISP can utilize the "recursive route lookups" so
the "next-hop" may not actually need to be a directly
connected neighbour -- the internal router can e.g.,
point to a loopback interface on the border router.
This can become "really uncomfortably messy" and it may
be necessary to use a distribute-list to prevent
the announcement of the shorter mask.

o Workaround for 9.0 or older software: create a
"default subnet route": "ip route 39.x.y.0 <next-hop>"
combined with "ip default-network 39.x.y.0", otherwise
as the 9.1 fix.

Both of the latter solutions rely on manual configuration, and in the
long run these will be impossible to maintain. In some topologies
the use of manual configuration can be a problem (e.g., if there is

more than one possible exit point from the AS to choose from).

Recommendations:

The RFC1797 experiment appears to have been a success. We believe it
safe to start carving up "Class A" space, if the spaces are delegated
according to normal IR conventions [7] and recommend the IANA
consider this for future address delegations.

Credits:

Thanks to all the RFC1797 participants. Particular thanks to Paul
Vixie, Geert Jan de Groot, and the Staff of the IETF33 Terminal room.
Other thanks to ACES, MCI, Alternet, IIJ, UUNET-Canada, Nothwestnet,
BBN-Planet, cisco systems, RIPE, RIPE NCC, ESnet, Xlink, SURFnet,
STUPI, Connect-AU, INBEnet, SUNET, EUnet, InterPath, VIX.COM,
MindSpring. Especial thanks to Suzanne Woolf for cleanup.

References:

[1] IANA, "Class A Subnet Experiment", RFC1797, USC/Information
Sciences Institute, April 1995.

[2] Eidnes, H., and G. J. de Groot, "Classless in-addr.arpa
delegation", Work in Progress, SINTEF RUNIT, RIPE NCC, May 1995.

[3] Huston, G., "Observations on the use of Components of the Class A
Address Space within the Internet", Work in Progress, AARnet, May
1995.

[4] Bates, T., et.al, "Representation of IP Routing Policies in a
Routing Registry", RFC1786, MCI, March 1995.

[5] http://info.ra.net/div7/ra/Ops.html, November 1995.

[6] Baker, F., Editor, "Requirements for IP Version 4 Routers", RFC
1812, cisco systems, June 1995.

[7] Hubbard, K., Kosters, M., Conrad, D., and D. Karrenberg,
"Internet Registry Guidelines", Work in Progress, InterNIC,
APNIC, RIPE, November 1995.

Security Considerations

Security issues were not considered in this experiment.

Editor's Address:

Bill Manning
Information Sciences Institute
University of Southern California
4676 Admiralty Way
Marina del Rey, CA 90292-6695
USA

Phone: +1 310-822-1511 x387
Fax: +1 310-823-6714

文章来源于领测软件测试网 https://www.ltesting.net/