客户那里有一个老的T3有问题，想进controller又不知道password。
老大们有没有什么办法，谢了
| wuzhengok 回复于：2003-10-15 08:48:49 |
| 重新设定机器ip。然后te.net进去修改。 |
| gang5415 回复于：2003-10-15 08:59:21 |
| 我也有同样的问题，请老大讲详细一点，好吗？ |
| fujitsu_solaris 回复于：2003-10-15 09:16:33 |
| 用ARP， |
| iamark 回复于：2003-10-15 13:47:35 |
| 楼上几位说的都不对啊，人家要是想知道passwd啊。
1. Stop all I/O going to the T3(s). 2. Connect a console cable from the master unit to a video terminal and power off all units (both trays in a partner group). 3. Power up the master unit (leave alternate master off) and interrupt the boot process by hitting RETURN when you see the following message: "hit the RETURN key within X seconds to cancel..." NOTE: If you leave the alternate master on, the T3 Operating System (OS) will continue to boot. Eventually, the OS will assume there is a problem with the master (that we interrupted), disable it, and make itself the master. 4. At the "T300-EP" prompt, use the 'set passwd' command to view (and memorize...) the password. 5. Type 'reset' to reboot, and immediately power on the alternate master (if present). 6. If you choose, you can change the password after it boots with the 'passwd' command. |
| wangy_80 回复于：2003-10-15 15:23:24 |
| 谢了，这就去试试 |
延伸阅读
文章来源于领测软件测试网 https://www.ltesting.net/