Tru64-FAQ-Hardware
Hardware 1 -- Where can I get information about Alpha chips?
www.alpha-processor.com
Hardware 2 -- What are the pinouts of the MMJ jacks?
This describes the 6-pin modified modular jack (MMJ) used for serial ports on various Digital hardware.
Digital carries four DB-to-MMJ adaptors. They are internally wired as follows:
Rdy Out TX+ TX- RX- RX+ Rdy In
Adaptor Gender 1 2 3 4 5 6 Use with:
--------------------------------------------------------------------
H8575-A F 20 2 7 7 3 6&8 VTxxx terminal
H8571-C M 6 3 7 7 2 20 Digital printer
H8571-D M 6 3 7 7 2 20 Modem
H8571-E M 20 2 7 7 3 6&8 Female terminal
or LaserWriter
--------------------------------------------------------------------
RS-232 using DB-25 connectors:
DTE DCE
Terminal Modem
or computer
Pin Number Signal Name
2 TD Transmit Data -->
3 RD Receive Data <--
7 GND Ground ---
6 DSR Data Set Ready <--
8 DCD Data Carrier Detect <--
20 DTR Data Terminal Ready -->
Hardware 3 -- Where can I get a disktab entry for the XXX disk?
newfs is smart enough to get the geometry of the disk from the drive, although this feature is not documented for all versions. Use:
newfs /dev/rrz#x /dev/rrz#x
For most uses, you don't need a disktab entry on Digital UNIX. The disklabel command can get the default partition table and geometry from the disk driver and will put that in the label. When the label is present, newfs doesn't need a disktab entry either.
A collection of contributed disktab entries is in /pub/DEC/ultrix-disktabs on the usual archive machines. Get a copy of the file for an up-to-date list. The disktab collection may also be used on Digital UNIX, but not all entries have been tested on all platforms.
Hardware 4 -- How can I read/write MS-DOS floppy disks?
If you have a floppy disk drive on your ULTRIX or OSF/1 system, get "mtools", a set of MS-DOS utilities for UNIX. The package can be copied from ftp://prep.ai.mit.edu/pub/gnu/mtools-2.0.7 It works on both DECstations and Alphas.
When you build mtools, you need to find out which device your floppy is (/dev/rrz2c is common). Then you can clone the SPARC definitions, or #define SPARC and make /dev/rfd0c a symlink to the one you need.
Hardware 5 -- How can I get disktab information for a new disk?
For disks that do not have entries in the /etc/disktab file, the following disklabel command will query the disk itself for geometry information:
disklabel -rw /dev/rrzXc unknown
Where /dev/rrzXc is the device name of the disk.
| lqy009 回复于：2003-08-01 15:55:52 |
| 东西这么多，啥时能看完！ |
延伸阅读
文章来源于领测软件测试网 https://www.ltesting.net/
